Olympus PT-018 Instrukcja Użytkownika Pobierz pdf (Strona 28)

E-27

Install the O-ring.

Confirm that no foreign matter is attached, apply a thin coat of the accessory

grease to the O-ring, and fit the O-ring into the groove. At this time, confirm

that the O-ring does not stick out from the groove.

：・When a mechanical pencil or a similar other sharp object is

used to remove the O-ring or to clean the inside of the O-

ring groove, the Case and the O-ring may be damaged and

water leakage may be caused.

・When the O-ring is checked with the fingertips, take care not

to stretch the O-ring.

・Never use alcohol, thinner, benzene or similar solvents or

chemicals detergents to clean the O-ring. When such

chemicals are used, it is likely that the O-ring will be

damaged or that its deterioration will be accelerated.

CAUTION

Use a clean cloth (that doesn't shed fibers), a toothbrush, tissue paper or the

like, to remove any foreign matter from the O-ring groove. Clean the O-ring

contact surface on the front lid in the same way to remove any sand and dirt.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 115 116

Brak uwag

Olympus PT-018 Instrukcja Użytkownika Strona 28